| Author |
Need help about openvms cluster issue |
linuck
Member
Posts: 2
Joined: 23.03.15 |
| Posted on March 23 2015 22:25 |
|
|
Hi:
everyboby I have a cluster openvms 8.4 running on rx2660,now there is a problem. serverA is running the apps serverB had halt ,i have new serverC can replace the serverB,when i connect any cables .power on serverC and the console had hung and show the message "%CNXMAN ,Have connection to quorum disk".
if everyone can help me please.thanks |
|
|
| Author |
RE: Need help about openvms cluster issue |
malmberg
Moderator
Posts: 530
Joined: 15.04.08 |
| Posted on March 24 2015 03:19 |
|
|
Is this a hobbyist system?
A quorum disk should only be used in a configuration where all voting nodes in the cluster can directly connect to it. For Itanium, this means either a SAN or shared SCSI bus.
From the sound of it, the Server C EFI bios boot setup is not the same as the server it replaced. And with out knowing details of your configuration it will be hard to diagnose.
If this is a business, I would recommend hiring a consultant to help you understand and properly set up your system for reliable operation. |
|
|
| Author |
RE: Need help about openvms cluster issue |
linuck
Member
Posts: 2
Joined: 23.03.15 |
| Posted on March 24 2015 04:27 |
|
|
Hi malmberg：
the serverC EFI bios boot setup is correct, It can san boot from the eva4400 storage array,but I don't know the what must be change on openvms cluster configuration?
thanks your replay. |
|
|
| Author |
RE: Need help about openvms cluster issue |
malmberg
Moderator
Posts: 530
Joined: 15.04.08 |
| Posted on March 24 2015 12:53 |
|
|
The cluster settings for ServerC depend on what your boot configuration is.
If you are running a common boot disk, you have to set the EFI boot flags to select the proper root on boot.
If you are running independent boot disks, then you need to make sure that you are booting into the correct disk.
|
|
|
